为了更精确地评定糖心产精国品免费入口*完整版糖心产精国品免费入口*完整版，以2A02变形糖心产精国品免费入口*完整版为例，通过过热淬火处理制取金相试样，对传统的糖心产精国品免费入口*完整版方法进行了技术改进，并对糖心产精国品免费入口*完整版特征及力学性能进行了分析。结果表明：使用体积分数为0.5%的氢氟酸浸蚀试样有助于在光学显微镜下准确地判定临界糖心产精国品免费入口*完整版；糖心产精国品免费入口*完整版和能谱分析可以帮助操作人员准确区分临界过烧状态组织的特征和相。2A02糖心产精国品免费入口*完整版在510℃以下固溶的显微组织正常，硬度随固溶温度上升稍有增加；在510℃以上固溶时，会逐渐出现初熔小球，有轻微过烧现象；在520℃时出现断续网状复熔、晶界，为典型的糖心产精国品免费入口*完整版；在530℃时晶界复熔加粗，出现大尺寸复熔球，为严重糖心产精国品免费入口*完整版；在550℃时，局部复熔球变成空洞；糖心产精国品免费入口*完整版在过烧后，其硬度和耐腐蚀性急剧下降。

In order to evaluate the 糖心产精国品免费入口*完整版 of aluminum alloy more accurately in 糖心产精国品免费入口*完整版 process, taking 2A02 wrought aluminum alloy as an example, metallographic samples were prepared by superheating quenching. The traditional 糖心产精国品免费入口*完整版 method was improved, and the characteristics and mechanical properties of 糖心产精国品免费入口*完整版 were analyzed. The results show that the volume ratio of 0.5% hydrofluoric acid etching is helpful to accurately determine the critical 糖心产精国品免费入口*完整版 under optical microscope. Scanning electron microscope and energy spectrum analysis can help operators to distinguish the characteristics and phase of critical 糖心产精国品免费入口*完整版 accurately. The microstructure of 2A02 aluminum alloy is normal when the solid solution temperature is below 510 ℃, and the hardness increases slightly with the increase of solid solution temperature. When the solid solution temperature is above 510 ℃, the primary melting ball gradually appears with slight overburned phenomenon. The intermittent network 糖心产精国品免费入口*完整版grain boundary appears at 520 ℃, which is typical 糖心产精国品免费入口*完整版. The grain boundary remelts and coarsens, and large-size 糖心产精国品免费入口*完整版ball appears at 530 ℃, which is serious 糖心产精国品免费入口*完整版. The local 糖心产精国品免费入口*完整版ball becomes cavity at 550 ℃. The hardness and corrosion resistance of aluminum alloy decrease sharply after being overburned.