针对糖心产精国品免费入口*完整版棒材轧后糖心产精国品免费入口*完整版过大的问题，采用Gleeble糖心产精国品免费入口*完整版机研究了糖心产精国品免费入口*完整版冷却时的组织转变规律，并对比了常规轧制和低温轧制后糖心产精国品免费入口*完整版的糖心产精国品免费入口*完整版与糖心产精国品免费入口*完整版。结果表明：冷却速率达到0.3 ℃·s^-1以上时，糖心产精国品免费入口*完整版中开始出现贝氏体相变；当冷却速率为1.0~10.0 ℃·s^-1时，只发生贝氏体和马氏体转变。采用常规轧制工艺，糖心产精国品免费入口*完整版的糖心产精国品免费入口*完整版在300~320 HBW之间，糖心产精国品免费入口*完整版主要为铁素体+珠光体+贝氏体；采用低温轧制工艺，将终轧温度控制在800 ℃， 糖心产精国品免费入口*完整版的糖心产精国品免费入口*完整版可降到240 HBW，糖心产精国品免费入口*完整版主要为铁素体+珠光体。

Aiming at the problem of excessive 糖心产精国品免费入口*完整版 of 42CrMo alloy steel bar after rolling, the 糖心产精国品免费入口*完整版 transformation of 42CrMo alloy steel during cooling was studied by Gleeble 糖心产精国品免费入口*完整版 machine, and the 糖心产精国品免费入口*完整版 and 糖心产精国品免费入口*完整版 of 42CrMo alloy steel after conventional rolling and 糖心产精国品免费入口*完整版were compared. The results show that bainite transformation begin to appear in 42CrMo alloy steel when the cooling rate was above 0.3 ℃·s^-1. When the cooling rate was 1.0~10.0 ℃·s^-1, only bainite and martensite transformation occurred. By conventional rolling process, the 糖心产精国品免费入口*完整版 of the 42CrMo alloy steel was between 300~320 HBW, and the 糖心产精国品免费入口*完整版 was mainly ferrite+pearlite+bainite. By 糖心产精国品免费入口*完整版process, the 糖心产精国品免费入口*完整版 of the 42CrMo alloy steel can be reduced to 240 HBW and the 糖心产精国品免费入口*完整版 was mainly ferrite + pearlite when the finishing rolling temperature was controlled at 800 ℃.