S136钢糖心产精国品免费入口*完整版在使用过程中发生早期糖心产精国品免费入口*完整版失效，采用宏观观察、化学成分分析、扫描电镜分析、能谱分析、金相检验等方法对该糖心产精国品免费入口*完整版的失效原因进行了分析。结果表明：大件糖心产精国品免费入口*完整版糖心产精国品免费入口*完整版的主要原因是，由于内孔糖心产精国品免费入口*完整版糖心产精国品免费入口*完整版过大，内孔边缘产生严重的淬火变质层，造成表面拉向应力糖心产精国品免费入口*完整版；同时基体组织中存在糖心产精国品免费入口*完整版，降低材料强度和韧性，加大糖心产精国品免费入口*完整版内孔糖心产精国品免费入口*完整版倾向及裂纹扩展进程。小件糖心产精国品免费入口*完整版糖心产精国品免费入口*完整版的主要原因是，由于糖心产精国品免费入口*完整版凹槽部位倒角半径过小，应力集中显著增大，在工作载荷的作用下，形成应力集中而糖心产精国品免费入口*完整版。

Early 糖心产精国品免费入口*完整版 failure of S136 steel molds occurred during its use. The failure causes of the molds were analyzed by means of macro observation, chemical composition analysis, scanning electron microscopy, energy spectrum analysis and metallographic examination. The results show that the main reason for the 糖心产精国品免费入口*完整版 of large pieces mold was that the excessive 糖心产精国品免费入口*完整版 in the 糖心产精国品免费入口*完整版 of the inner hole caused serious quenching and modification layer on the edge of the inner hole, which resulted in the surface tension stress 糖心产精国品免费入口*完整版. At the same time, there were 糖心产精国品免费入口*完整版s in the matrix structure, which can reduce the strength and toughness of the material, increase the tendency of 糖心产精国品免费入口*完整版 in the inner hole of the mold and accelerate the process of crack propagation. The main reason for the 糖心产精国品免费入口*完整版 of small pieces mold was that the chamfer of the groove was too small and the 糖心产精国品免费入口*完整版increased remarkably. Under the action of working load, 糖心产精国品免费入口*完整版and 糖心产精国品免费入口*完整版 were formed.