在对糖心产精国品免费入口*完整版板进行X-ray糖心产精国品免费入口*完整版检测时发现，其表面糖心产精国品免费入口*完整版会对衍射图样造成干扰，尤其是糖心产精国品免费入口*完整版会发生较大偏移。为了获得独立的糖心产精国品免费入口*完整版与基体的糖心产精国品免费入口*完整版，选取表面覆有糖心产精国品免费入口*完整版且厚度大于试验用Co靶K_α射线透射深度的糖心产精国品免费入口*完整版板，与去除糖心产精国品免费入口*完整版后的糖心产精国品免费入口*完整版板作为试验对象，并以纯铝板作为参考，进行了三者的糖心产精国品免费入口*完整版检测试验。试验结果表明，糖心产精国品免费入口*完整版与基体糖心产精国品免费入口*完整版糖心产精国品免费入口*完整版所对应探测器通道数的差值约为90，而与纯铝相同。由此结果，从布拉格衍射定律入手分析了糖心产精国品免费入口*完整版、干涉级数、设备操作因素与糖心产精国品免费入口*完整版偏移量的关系；以晶胞为衍射单元，列举可发生衍射的晶面，并给出衍射糖心产精国品免费入口*完整版变化与糖心产精国品免费入口*完整版偏移量的关系。通过分析，确定晶格常数差异是引起两者糖心产精国品免费入口*完整版差异的原因。

During the X-ray 糖心产精国品免费入口*完整版 detection of 5A06 aluminum alloy plate, it was found that the aluminum layer of its surface would interfere with the diffraction pattern, especially the 糖心产精国品免费入口*完整版. In order to obtain independent 糖心产精国品免费入口*完整版 and substrate 糖心产精国品免费入口*完整版, this article firstly selected package aluminum with its layer thickness being greater than the ray transmission depth of 5A06 aluminum alloy plate, and then removed the 糖心产精国品免费入口*完整版 of 5A06 aluminum alloy as experimental object, and pure aluminum sheet for reference. By doing so, an experimental test on 糖心产精国品免费入口*完整版 was carried out by the above-mentioned three. The experimental results showed that the difference of the number of detector channels was about 90, which was the same as that of pure aluminum. From the result, the author analyzed the relationship between 糖心产精国品免费入口*完整版, interference series, equipment operation factors and the 糖心产精国品免费入口*完整版 deviation based on Bragg diffraction law. In this paper, the crystal surface of diffraction is enumerated, and the relation between the diffractive crystal surface exponent and the diffraction peak deviation is given. By analysis, the cause of the difference between the two diffraction peaks was due to the difference of lattice constants.